BM57 B-Master Cylinder RHD For Nissan Skyline Silvia Z32 ABS +Non ABS

HFM.Parts have re-developed their superseded Brake Master Cylinder with higher quality rubbers and internals, with a classic monochrome design.

With a whopping 17/16 Inch (27mm) piston bore size, this is the perfect application if you are looking to increase your braking performance and reduce that spongy feeling to give you a firmer brake pedal with less travel.

HFM.Parts have included a Tapered Grub Screw so that this model can be applied to both ABS and NON-ABS vehicles.

The dark color of HFM.Parts Brake Masters come from their Geomet® coating. As well as providing some heat protection and environmental resistance, this coating is environmentally friendly as it contains no Chromium, the leftover solution is recycled and no chemicals are evaporated.

Specifications
Split Point = 35kgf (498psi) x 0.4

TIP! – Soften your pedal feel by increasing the brake booster size.

Includes:

1x BM57 Brake Master Cylinder
1x Tapered Grub Screw

The product is suited for RHD models only.
*If you have ABS you will need to block the middle port with the provided tapered grub screw.

Applications:

Nissan Z32 / 300ZX
Nissan 180sx
Nissan S13 Silvia
Nissan S14 Silvia
Nissan S14/200sx
Nissan S15 Silvia
Nissan S15/200sx
Nissan Skyline R32
Nissan Skyline R33
Nissan Skyline R34

HFM FAQ

Q. My brake lines feed from the top, can I still use this Brake Master?
A. Yes. Although the HFM.Parts Brake Master is designed with side ports, most brake lines can be massaged around until they reach the brake master’s ports.

Q. My brake lines feed from the bottom, can I still use this Brake Master?
A. Yes. Although the HFM.Parts Brake Master is designed with side ports, most brake lines can be massaged around until they reach the brake master’s ports.

Q. The fluid sensor connector is on the wrong side, what can I do?
A. You can easily swap the sensor connector to either side of the HFM.Parts Brake Master by following these steps.
On the terminal side, push a small flat screwdriver in between the sensor connector and the bottom of the reservoir to lightly pry apart the lock tab. On the opposite side of the sensor connector, push through to pop it out. *This is much easier to do prior to installation!

Q. I have a round (or other shape) fluid sensor connector, will it fit?
A. No, our fluid sensor connector is rectangle (as shown in the product photo), in order to plug your existing fluid sensor connector into our one, you will need to cut your existing connector off and join the two exposed wires to individual spade terminals. Then, you can push these onto our connector.

Q. Will the proportioning valve suit my car?
A. The Sepcs for the HFM.Parts BM57 are “Split Point = 35kgf  (498psi) x 0.4” which can suit the models listed depending on the vehicles brake and suspension set up, your brake bias may differ.

Q. How will I know if this BM57 will suit my car?
A. Racing is all about optimising for performance, unfortunately, the only reliable way is to test suitability on a racetrack.